Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1089)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1073
Titrando: 835, 836, 842, 857, 902, 906, 907
Titrino: 718, 736, 751, 799
pH/Ion Meter: 867
Robotic Titrosampler: 855
Appearance
The command has the following appearance:
Parameters
The parameters for the command DOS pH are configured in the following
5 tabs:
￭ General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
￭ Dosing parameters
Parameters for the dosing settings.
￭ Stop conditions
Definition of conditions which cause the stop of the dosing.
￭ Monitoring
Definition of measured value and temperature monitoring.
￭ Additional measured values
Definition of additional measured values of other measuring commands
which are saved as additional columns in the measuring point list.
Command variables
The following command variables are generated in the method run by the
command DOS pH and can be used in formulas under the designation
'Command name.Variable designation':
Identifica-
tion Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.CONC Concentration of the solution used for the command
.CYL Cylinder volume of the exchange or dosing unit used for
the command
.DBL Total duration for the processing of the command in s