Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1340)

6.7 Subwindow Sensors ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1324 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Slope, E(0) and c(blank value), and for conductivity sensors the cell con-
stant.
Slope, pH(0), E(0), c(blank), cell constant
The values are shown in the following colors:
￭ Blue, when the values were determined automatically by a method.
￭ Black, when the values have been entered manually.
￭ Orange, when the values are outside the warning limits.
￭ Red, when the values are outside the intervention limits.
If the warning or intervention limits are exceeded then the line number will
also be shown with an orange and red background respectively.
Calibration date
Date and time of the calibration.
Calibration method
Name of the method with which the calibration was carried out. If the cal-
ibration data was entered manually then manual will appear here.
Note
This parameter is not saved on the data chip of intelligent sensors, i.e. this
parameter will be empty if the data are written into the sensor table from
the sensor.
User
Short name of the user logged in during calibration or when the calibration
data was entered manually. If work is not carried out using login then the
user logged in under Windows will be entered automatically.
Note
This parameter is not saved on the data chip of intelligent sensors, i.e. this
parameter will be empty if the data are written into the sensor table from
the sensor.
History graph
On the two tabs Slope and pH(0) or E(0) the last 10 values are shown for
the selected sensor. As in the history table, the values are shown in different
colors:
￭ Blue, when the values were determined automatically by a method.
￭ Black, when the values have been entered manually.