Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1346)

6.7 Subwindow Sensors ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1330 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Range -2.147E+9 ... 2.147E+9
Default value 7,500
Intervention limits for pH(0) (only for pH electrodes)
on | off (Default value: off)
If this option is enabled, then the values for pH(0) will be shown in red if
the limits are exceeded.
Lower limit
Lower intervention limit for pH(0).
Range -2.147E+9 ... 2.147E+9
Default value 6.000
Upper limit
Upper intervention limit for pH(0).
Range -2.147E+9 ... 2.147E+9
Default value 8.000
Warning limits for E(0) (only for ISE electrodes)
on | off (Default value: off)
If this option is enabled, then the values for E(0) will be shown in orange
if the limits are exceeded.
Lower limit
Lower warning limit for E(0).
Range -2.147E+9 ... 2.147E+9 mV
Default value -15 mV
Upper limit
Upper warning limit for E(0).
Range -2.147E+9 ... 2.147E+9 mV
Default value 15 mV
Intervention limits for E(0) (only for ISE electrodes)
on | off (Default value: off)
If this option is enabled, then the values for E(0) will be shown in red if the
limits are exceeded.
Lower limit
Lower intervention limit for E(0).