Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1272)

6.3 Configuration data ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1256 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Example: *******1 expects an active input line 0 (1 = set). For example, this
line is set by a Titrino after a titration has been completed and the Titrino
can accept a start signal again.
Note
Input lines that are of no interest or for which no defined condition can
be predicted should also be masked with an asterisk *.
6.3.3.3 Templates for output lines
6.3.3.3.1 Managing templates for output lines
Dialog window: Configuration ▶ Tools ▶ Templates ▶ Output lines... ▶ Templates
for output lines
The client-specific bit-pattern for setting remote output signals can be
defined in the dialog window Templates for output lines; these can be
selected with the command CTRL and in Manual Control. The table with
the defined templates cannot be edited, although it can be sorted according
to the selected column in increasing or decreasing sequence by clicking on
the column title
[New]
Generates a new template (see Chapter 6.3.3.3.2, page 1256).
[Edit]
Edits the selected template (see Chapter 6.3.3.3.2, page 1256).
[Delete]
Deletes the selected template.
6.3.3.3.2 Editing templates for output lines
Dialog window: Configuration ▶ Tools ▶ Templates ▶ Output lines... ▶ Templates
for output lines ▶ [New] / [Edit] ▶ New template / Edit template
With [New] or [Edit] the dialog window New template or Edit tem-
plate opens for entering a new template or for editing an existing template.
Creating new template or editing template
With <New> or <Edit> the dialog window New template or Edit tem-
plate opens for entering a new template or for editing an existing template.
Signal name
Name of the pattern for the output signal.
Input 25 characters