Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1090)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1074 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Identifica-
tion Description
.EME Final measured value (measured value after processing
of the command) in the unit of the measured value
.ENP Electrode zero point of the sensor used for the command
(dimensionless)
.ETE End temperature (temperature following processing of
the command) in °C
.EVT End volume (total dosed volume at the end of the com-
mand) in mL
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended
.IME Initial measured value (measured value before start con-
ditions are processed) in the unit of the measured value
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.CAx Calculated value × (1...3) for the last measuring point of
the measuring point list
.LP.DVT dV/dt for the last measuring point in the measuring point
list (SET, KFT, STAT, DOS) or drift for the last measuring
point in in the measuring point list in µg/min (KFC)
.LP.EXx External value × (1...3) for the last measuring point of the
measuring point list
.LP.MEA Measured value for the last measuring point in the unit
of the measured value of the measuring point list
.LP.TEM Temperature for the last measuring point of the meas-
uring point list in °C
.LP.TIM Time in s until the last measuring point in the measuring
point list is reached
.LP.VOL Volume for the last measuring point in the measuring
point list in mL
.MR.MRC Correlation coefficient for mean dosing rate for the
whole range
.MR.MRS Standard deviation for mean dosing rate for the whole
range in mL/min
.MR.MRT Mean dosing rate for the whole range in mL/min.