Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 49)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 2 General program functions
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 33
Note
In the case of variables with Index {x}, the desired number 1…9 must be
entered for x (e.g. .EP{3}.ERC for the third endpoint).
If no index is specified, then the last index will be used automatically
(e.g. .EP.ERC for the last endpoint).
For the commands ANALOG IN, ANALOG OUT, DIGITAL IN, DIGI-
TAL OUT and STEPPING MOTOR, the syntax is 'Command-
name.Portname.Variabledesignation'.
Identifica-
tion Description Commands
.BLV Blank value for the sensor used for
the command (only for ISE sensor)
and/or blank value calculated from
the calibration (for CAL LOOP Conc) DET U, MET U,
SET U, STAT U,
MEAS U, MEAS
Conc, CAL LOOP
Conc, DOS U
.BP{x}.CNT Intensity for the break point x (1…
9) in counts MEAS Opt
.BP{x}.DME Measured value differential for the
break point x (1…9) MET
.BP{x}.ERC ERC or first derivative for the break
point x (1…9) DET
.BP{x}.MEA Measured value for the break point
x (1...9) in the unit of the measured
value DET, MET, MEAS
(without T/Flow,
Ref, Spec)
.BP{x}.TEM Temperature for the break point x
(1…9) in °C DET, MET, MEAS
(without T/Flow,
Ref, Spec)
.BP{x}.TIM Time for the break point x (1…9) in
s DET, MET, MEAS
(without T/Flow,
Ref, Spec)
.BP{x}.TRN Transmission for the break point x
(1...9) in % MEAS Opt
.BP{x}.VOL Volume for the break point x (1…9)
in mL DET, MET