Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 442)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
426 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Conditioning
Automatic conditioning
on | off (Default value: on)
If this option is enabled, the conditioning will be started automatically at
the start of a determination for all commands with activated conditioning
(SET, KFT, KFC and BRC). After the track with the conditioning command
has been finished, conditioning is started again automatically and will be
continued even after the end of the determination.
If this parameter is disabled, then conditioning will not be started until the
start of the command. Conditioning is not started again after the end of the
track with the conditioning command. This parameter must be switched off
for automation applications.
5.6.2.2.3 START - Application note
Tab: Method ▶ START ▶ Properties... ▶ START 'Command name' ▶ Application note
Command name
Name of the command.
Input 25 characters
The application note defined in the text window is displayed in the tab
Application note in the subwindow Live display of the program part
Workplace. The tab is opened automatically when the method is loaded.
The text editor with which the application note can be entered or changed
is opened with or by double-clicking into the text field (see Chapter
2.5.2, page 84).
5.6.2.2.4 START - Method variables (Table)
Tab: Method ▶ START ▶ Properties... ▶ START 'Command name' ▶ Method variable
Command name
Name of the command.
Input 25 characters
The variables that are to be available within the method in other commands
(e.g. CALC command) under the designation MV.'Variable name' must
be declared here. Either a sample data variable (entry in field Assign-
ment) or a direct value (entry in field Value) can be assigned to a method
variable.
The overview table shows all of the declared method variables and can itself
not be edited directly. With a click on the column title (columns Name,