Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1324)

6.7 Subwindow Sensors ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1308 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Acoustic signal
on | off (Default value: off)
If this option is enabled, an acoustic signal will be emitted additionally to the
message defined above
Action
The actions can only be edited if monitoring is switched on.
If during monitoring it is found that the validity period has expired then one
of the following actions will be triggered automatically at Start test.
Selection Record message | Display message | Stop deter-
mination
Default value Display message
Record message
The message that the validity period has expired will be automatically
saved with the determination.
Display message
A message is displayed and you can choose whether you want to con-
tinue the run or cancel it. If the run is continued then the message that
the validity period has expired will be automatically saved with the deter-
mination.
Stop determination
The running determination will be automatically terminated. The follow-
ing message must be confirmed with [OK].
6.7 Subwindow Sensors
6.7.1 Sensors - General
Subwindow: Configuration ▶ Sensors
Subwindow Sensors
The subwindow Sensors contains the Sensor table with automatically rec-
ognized and manually added sensors. It can be shown in the program part
Configuration as a part of the Configuration view or (if not present on the
desktop) in a separate window with View
▶ Quick access. The subwindow
can be enlarged and reduced as required; it can also be maximized.
Intelligent sensors (IS)
Intelligent sensors have a data chip with stored sensor data. When connec-
ted to intelligent devices (e.g. 857 Titrando) via 854 iConnect, they are
recognized automatically and stored in the sensor table.
Non-intelligent sensors
Non-intelligent sensors must be added manually to the sensor table.