Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1509)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 7 Devices
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1493
Stop determination
The running determination will be automatically terminated. The follow-
ing message must be confirmed with [OK].
7.20 Stepping motor controller
7.20.1 Stepping motor controller - Overview
Dialog window: Configuration ▶ Devices ▶ [Edit] ▶ Properties ▶ Properties - 'Device
type' - 'Device name'
The properties of a stepping motor controller are set on the following tabs:
￭ (see Chapter 7.19.2, page 1478)
General device information such as device name, device type, serial num-
ber, etc.
￭ (see Chapter 7.19.3, page 1479)
General settings for the IO controller.
￭ (see Chapter 7.19.4, page 1480)
Digital inputs of the IO controller.
￭ (see Chapter 7.19.5, page 1483)
Digital outputs of the IO controller.
￭ (see Chapter 7.20.6, page 1501)
Stepping motors of the IO controller.
￭ (see Chapter 6.6.3.8, page 1306)
Information on GLP tests and GLP monitoring.
7.20.2 Properties - General
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ General
Device name
Name of device (can be freely defined by user).
Input 50 characters
Default value Device type number_#
Device type
Display or selection of the device type.
Wrapper version
Display of the version of AdsWrapper.dll.
Firmware version
Display of the SPS firmware version on the bus controller. Combined of the
bus controller firmware and the version of the bus controller program.