Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 52)

2.4 Formula editor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
36 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Identifica-
tion Description Commands
.EP{x}.DME Measured value differential for the
endpoint x (1…9) MET
.EP.DVT Drift for the endpoint x (1…9) in
µg/min KFC, BRC
.EP{x}.ERC ERC for the endpoint x (1…9) DET
.EP{x}.MEA Measured value for the endpoint x
(1…9) in the unit of the measured
value DET, MET, SET,
KFT, KFC, BRC
.EP{x}.MEP Quantity of endpoints in the win-
dow x (1…9); 1 = 1 endpoint, 2 =
2 or more endpoints, 3 = EP
corrected with Autodrift, 4 =
EP corrected with manual drift DET, MET, SET,
KFT
.EP.QTY Measured value for the endpoint in
µg KFC, BRC
.EP{x}.TEM Temperature for the endpoint x
(1…9) in °C DET, MET, SET,
KFT, KFC, BRC
.EP{x}.TIM Time in s until the endpoint x (1...9)
is reached DET, MET, SET,
KFT, KFC, BRC
.EP{x}.UGE Voltage at the generator electrode
for endpoint # (1...9) in V. In case of
measurements with 756, 831: 0 =
not defined, 1 = <14V, 2 =
14...28V, 3 = >28V KFC, BRC
.EP{x}.VOL Volume for the endpoint x (1…9) in
mL DET, MET, SET,
KFT
.EPP Position after finishing the com-
mand. 0 = invalid position. PORT
.ETE End temperature (temperature fol-
lowing processing of the com-
mand) in °C DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without T/Flow,
Ref, Spec), CAL
MEAS, STDADD,
DOS
.EVT End volume (total dosed volume at
the end of the command) in mL DET, MET, SET,
KFT, STAT, DOS