H3C Technologies H3C Intelligent Management Center - Manual (Page 130)

112
2. In the Query Endpoint IP Groups area, specify one or more of the following query criteria:
{
Endpoint IP Group Name—Enter the endpoint IP group name. UAM supports fuzzy matching for
this field. For example, if you enter office, all endpoint IP groups whose names contain office are
queried.
{
Service Group—Select Ungrouped or a service group from the list.
{
IP Address—Enter the complete IPv4 or IPv6 address. You can also enter an IPv6 address in
compressed format. Use this parameter to query endpoint IP groups that contain the specified
IPv4 or IPv6 address.
Empty fields are ignored.
3. Click Query to perform the query. The endpoint IP group list shows all endpoint IP groups that
match the query criteria.
4. Click Reset to clear the query criteria. The endpoint IP group list shows all endpoint IP groups in
UAM.
Adding an endpoint IP group
1. Access the endpoint IP group list page.
2. Click Add to display the page for adding an endpoint IP group.
3. Configure the following parameters:
{
Endpoint IP Group Name—Enter the name of the endpoint IP group, which must be unique in
UAM.
{
IP Type—Select an IP address type. Select IPv4 to add an endpoint IPv4 group. Select IPv6 to
add an endpoint IPv6 group.
{
Start IP/End IP—Enter the start and end IP addresses of the endpoints for the endpoint IP group.
Enter IPv4 addresses if the IP Type is IPv4. Enter IPv6 addresses if the IP Type is IPv6. Make sure
IP addresses among endpoint IP groups do not overlap.
{
Service Group—Select a service group for the endpoint IP group. You can add endpoint IP
groups to different service groups to facilitate management.
4. Click OK.
Modifying an endpoint IP group
1. Access the endpoint IP group list page.
2. Click the Modify icon for the endpoint IP group you want to modify.
The page for modifying the endpoint IP group appears.
3. Modify the endpoint IP group parameters.
You can modify only the Start IP and End IP fields. For more information about the parameter
description, see "
Adding an endpoint IP group ."
4. Click OK.
Deleting an endpoint IP group
An endpoint IP group cannot be deleted when it is used in an access scenario.
To delete an endpoint IP group: