H3C Technologies H3C Intelligent Management Center - Manual (Page 312)

294
b. Enter a complete IPv6 address or an IPv6 address in compressed format in the Start IPv6
Address field. The field does not support a partial IPv6 address. The parameter specifies the
first IPv6 device to be added to UAM.
c. Enter a value in the IPv6 Address Span field. The parameter specifies the total number of IPv6
devices to be added to UAM. UAM then add the IPv6 devices in ascending order of their IP
addresses with the first device specified by the Start IPv6 Address parameter.
d. Enter the remarks of the access device to facilitate maintenance.
e. Click OK to return to the page for adding access devices. The added devices are displayed in
the Device List.
f. Click Clear All in the Device List area to remove all the devices from the device list. You can
click the Delete icon for a single device to delete it.
7. Click OK.
The configuration result page appears. In this page, you can continue to configure ACLs, add
access devices, or go back to the access device list. The Configure ACL link displays only after you
deploy an ACL management component. Click the Add Access Device link to continue adding
access devices. Click the Back to Access Device List link to view the added access devices in the
Access Device List. Click the Configure ACL link to configure ACLs for the access devices.
8. Configure ACLs.
a. Click the Configure ACL link. The page displays a list of devices that support ACLs and one that
do not support ACLs.
b. Click Next.
The page for selecting ACLs appears.
c. Select one or more ACLs that already exist in the ACL management component in the ACL
resource list.
d. Click Next.
e. Deploy ACLs in the ACLs to Deploy list.
ACLs to Deploy list contents
− Duplicate Name—Checks whether or not an ACL with the same name already exists on the
device. This parameter helps the administrator determine the deployment strategy to use.
− Device Compatible—Whether or not the access device supports the ACL to be deployed.
− Deploy Strategy—Includes Not Deploy, Add, and Append. Select Not Deploy for an access
device that does not support the ACL to be deployed. Select Add for an access device that
does not have an ACL of the same name configured and supports the ACL to be deployed.
Select Not Deploy or Append for an access device that has an ACL of the same name
configured and supports the ACL to be deployed.
f. Click Deploy.
A confirmation dialog box appears.
g. Click OK.
For more information, see HP Intelligent Management Center v7.0 Enterprise and Standard
Platform Administrator Guide.
Adding an MSM teamed controller
When an MSM teamed controller is added to the IMC platform or WSM, it is identified by the virtual IP
address. To add the controller to UAM, you must specify the physical IP address of the controller. Do not
add MSM teamed controllers by selecting from the IMC platform.