Deleting hard disk serial numbers, Configuring access mac addresses, Setting mac filter – H3C Technologies H3C Intelligent Management Center User Manual
Page 154
136
4.
Click OK.
Deleting hard disk serial numbers
1.
Access the hard disk serial number list page.
2.
Select one or more hard disk serial numbers you want to delete, or select the box in the table
heading to select all hard disk serial numbers.
3.
Click Delete.
A confirmation dialog box appears.
4.
Click OK.
Configuring access MAC addresses
UAM can control user access by MAC address. When a service requires MAC address check for
endpoint users, the following rules apply:
•
If the endpoint MAC address is permitted, the user can access the network.
•
If the endpoint MAC address is not permitted, the user cannot access the network.
•
If UAM cannot obtain the endpoint's MAC address or the obtained MAC address is empty, the user
can access the network.
The permitted access MAC address range is determined by a permitted or a denied access MAC list. For
more information, see "
Setting MAC filter
The following MAC filters are available:
•
Permit—Enables the administrator to specify MAC addresses that are permitted to access the
network. A user endpoint whose MAC address is in the permitted MAC address list can access the
network successfully. Otherwise, the user cannot access the network. If no permitted MAC address
is specified, all users can access the network.
•
Deny—Enables the administrator to specify MAC addresses that are denied to access the network.
A user endpoint whose MAC address is in the denied MAC address list is not allowed to access the
network. Otherwise, the user can access the network.
To set the MAC filter:
1.
Click the User tab.
2.
Select User Access Policy > Access Condition from the navigation tree.
3.
Hover over the icon to the right of the menu and click Access MAC Address to display the list.
4.
Remove all MAC addresses from the list.
5.
Click Set MAC Filter (Current: Permit) or Set MAC Filter (Current: Deny) on the upper right corner.
The Set MAC Filter page appears.
6.
Select Permit or Deny for MAC Filter.
7.
Click OK.