H3C Technologies H3C Intelligent Management Center - Manual (Page 309)

291
{
Access Device Type—Access device vendor and type. Predefined access device types include
STANDARD(Standard), H3C(General), 3COM(General), HUAWEI(General), CISCO(General),
RG(General), HP(MSM), HP(Comware), HP(ProCurve), MICROSOFT(General), and
Juniper(General). The administrator can set user-defined types. For more information, see
" Configuring access device types ."
{
RADIUS Accounting—Includes the Fully Supported and Partially/Not Supported options. The
former indicates that the access device supports Accounting Start, Accounting Stop, and
Accounting Update packets. The latter indicates that the access device supports some or none
of the previous packets.
{
Shared Key—Shared key used by the access device and UAM to authenticate each other. The
value must be the same as what is configured on the access device in the CLI.
{
Service Group—Service group to which the access device belongs.
{
Last Deployed at—Time when UAM last attempted to deploy configurations to the access device.
This field is empty when UAM has not deployed any configuration to the device.
{
Deploy Result—Last deploy result on the access device. This field is valid only for devices of the
H3C wired, H3C wireless, and HP wired configuration types. This field displays Not Deployed
when UAM has not deployed any configuration to the device. This field displays Deploying
when UAM is deploying configurations to the device.
{
Deploy Failure Reason—Reason why the last configuration deploy attempt failed. This field is
empty if the last configuration deployment is successful.
{
Last Synchronized at—Time when UAM last attempted to synchronize port configuration from
the access device. This field is empty when UAM has never synchronized port configuration from
the device.
{
Port Synchronization Result—Last port configuration synchronization result on the access device.
You must synchronize the port configuration of an access device to UAM before deploying port
configurations to the device. This field is valid only for devices of the H3C wired, H3C wireless,
and HP wired configuration types. If the access device is not a switch, UAM does not deploy port
configurations to the device and displays No Sync Needed.
{
Synchronization Failure Reason—Reason why the last synchronization attempt failed. This field
is empty if the last synchronization operation is successful.
{
Configuration Type—This field is automatically populated with the type of device configuration
that can be deployed to the access device: H3C Wired, H3C Wireless, or HP Wired. An empty
field indicates that UAM cannot deploy any configurations to the access device. IMC read this
parameter of the access device when it was added to the IMC platform.
3. To return to the access device list page, click Back.
Adding access devices
Adding an access device
1. Access the access device list page.
2. Click Add.
The Add Access Device page appears.
3. Configure the following common parameters in the Access Configuration area:
{
Authentication Port—Enter the port to which UAM listens for RADIUS authentication packets.
The port must be the same as what is configured on the access device in the CLI.