H3C Technologies H3C Intelligent Management Center - Manual (Page 195)

177
Authentication
username
Authentication domain
on the access device
Commands configured on the
access device
Service suffix in
UAM
(Default domain on the
access device)
user-name-format without-domain None
NOTE:
The commands in Table 19 are available on HP Comware devices. The commands used on other access
devices may vary.
5. Configure the access device binding information.
The binding parameters in this area take effect only when they are selected in the Authentication
Binding Information area of the selected services. For example, the Device IP parameter applies to
services with the Bind Access Device IP option selected.
If you select a binding option for a service without specifying a value for the parameter in the
Access Device Binding Information area, UAM automatically acquires the binding information for
the service when a user first passes authentication.
To pass authentication, the access user must meet all requirements of the access device bindings
and terminal bindings.
{
Device SN—Enter the sequence number of the access device to which the access user is
connected.
{
Port—Enter the port through which the access user is connected to the access device. The value
is the last portion of a device port. For example, if an access user is bound to port 3, the user can
access from port 1/0/3 or port 2/0/3.
{
Outer VLAN ID—Enter the outer VLAN ID that is contained in the access user's packets.
{
VLAN ID/Inner VLAN ID—Enter a list of VLAN IDs or inner VLAN IDs that can be contained in
the access user's packets.
{
User SSID—Enter a list of SSIDs to which the access user can be connected.
{
Device IP—Enter a list of IPv4 address for the access devices to be bound to the access user.
Each entry on the list represents the IP address of an access device bound to the access user. If
a device has multiple IP addresses, use the IP address of the corresponding access device in
UAM.
{
Device IPv6 Address—Enter a list of IPv6 address for the access devices to be bound to the
access user. Each entry on the list represents the IPv6 address of an access device bound to the
access user. If a device has multiple IPv6 addresses, use the IPv6 address of the corresponding
access device in UAM.
6. Configure the terminal binding information.
The binding parameters in this area take effect only when they are selected in the Authentication
Binding Information area of the selected services. For example, the Computer Name parameter
applies to services with the Bind Computer Name option selected.
If you select a binding option for a service but do not specify a value for the parameter in the
Access Device Binding Information area, UAM automatically acquires the binding information for
the service when a user first passes authentication.
To pass authentication, the access user must meet all requirements of the access device bindings
and terminal bindings.
{
Computer Name—Enter the name of the computer to be bound to the access user.
{
IMSI—Enter the IMSI of the endpoint to be bound to the access user.