Lenze 8400 TopLine - Manual (Page 1014)

17 Parameter reference
17.2 Parameter list | C00583
1014
Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00583
C00585
C00586
Parameter | Name:
C00583 | Resp. to motor temperature KTY
Data type: UNSIGNED_8
Index: 23992
d
= 5DB8
h
Response to motor overtemperature
• The motor temperature is measured via the resolver or encoder cable.
 Encoder/feedback system: Motor temperature monitoring (KTY)
Selection list
0 No Reaction
1 Fault
3 TroubleQuickStop
4 WarningLocked
5 Warning
6 Information
Subcodes Lenze setting Info
C00583/1 1: Fault Resp. to motor overtemp. KTY resolver
C00583/2 1: Fault Resp. to motor overtemp. KTY MultiEncoder
C00583/3 5: Warning Resp. to motor temp. > C00121 resolver
C00583/4 5: Warning Resp. to motor temp. > C00121 encoder
C00583/5 1: Fault Resp. to temp. sensor error KTY resolver
C00583/6 1: Fault Resp. to temp. sensor error KTY MultiEncoder
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00585 | Resp. to motor overtemp. PTC
Data type: UNSIGNED_8
Index: 23990
d
= 5DB6
h
Response to motor overtemperature
• The motor temperature is measured by means of a PTC thermistor at terminal X106.
Selection list (Lenze setting printed in bold)
0 No Reaction
1 Fault
5 Warning
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00586 | Resp. to open circuit HTL encoder
Data type: UNSIGNED_8
Index: 23989
d
= 5DB5
h
Response to encoder feedback system failure or encoder feedback system track failure due to open circuit
Selection list
(Lenze setting printed in bold)
0 No Reaction
1 Fault
5 Warning
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1