Lenze 8400 TopLine - Manual (Page 1682)

19 Function library
19.1 Function blocks
1682
Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
19.1.171.1 Definition of the switching range
Depending on the setting of the CenterMode ( C01064/x ), the switching range can be defined via a
start and end position or via the data of the center point/size of switching range:
[19-73] Definition of the switching range
C01065/1...8 0 ms 60000 Running time for position/time-
based cams
• Lenze setting: 0 ms
0 ms = position-based cam
C01066/1...8 Status 1 ... 4
• Read only.
0 OK
10 FB is not active
100 Switching points not plausible
C01068/1
From version 12.00.00
Setting is bit coded: Inversion of outputs
• Lenze setting: 0x0000
Bit 0 Inversion of output 1
Bit 1 Inversion of output 2
Bit 2 Inversion of output 3
Bit 3 Inversion of output 4
Bit 4 Inversion of output 5
Bit 5 Inversion of output 6
Bit 6 Inversion of output 7
Bit 7 Inversion of output 8
Bit 8 Reserved
...
Bit 15
Parameter Possible settings Info
dnSwitchPoint1_p dn2ndPoint_Size1_p
dnSwitchPoint1_p
CenterMode = FALSE
dn2ndPoint_Size1_p
CenterMode = TRUE