Lenze 8400 TopLine - Manual (Page 1485)

Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
1485
19 Function library
19.1 Function blocks
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Linear torque characteristic
• nD0_a serves to define at which diameter the tensile force decrease is to start.
• Since in this characteristic selection, the linear torque profile is in the focus, define in this case
the slope of the torque curve via dnCurveCtrl_n:
• When nCurveCtrl_a = 100 %, the tensile force remains unchanged.
• When nCurveCtrl_a = 0 %, the tensile force is reduced up to D0/DMax.
Characteristic for a linear torque profile ( C01035/1 = 2)
Characteristic

Tensile force
 Diameter
Function for D > D0:
D Current diameter (nDiameter_a)
D0 Starting point for diameter dependency (nD0_a)
HW Tensile force evaluation (nCurveCtrl_a)
Example: Steepness of the torque curve
Characteristic

Torque
 Diameter
D Current diameter (nDiameter_a)
D0 Starting point for diameter dependency (nD0_a)
Œ

DMin
(DMax)
D0 100 %
100 %
0 %
100 %
nCurveCtrl_a = 0 %
HW
HW
100 % HW
–
( ) D0 ⋅
D
------------------------------------------------ +
Œ

DMin
(DMax)
D0 100 %
100 %
0 %
100 %
nCurveCtrl_a
0 %
50 %