Lenze 8400 TopLine - Manual (Page 135)

Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
135
5 Motor control (MCTRL)
5.1 Motor selection/Motor data
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5.1 Motor selection/Motor data
The motor data term comprises all parameters that only depend on the motor and that only
characterise the electrical behaviour of the machine. The motor data are independent of the
application in which the controller and the motor are used.

Proceed as follows to open the dialog for parameterising the motor data:
1. »Engineer« Go to the Project view and select the 8400 TopLine controller.
2. Select the Application parameters tab from the Workspace.
3. Go to the Overview dialog level and click the following button:
Parameterisation dialog in the »Engineer«
• Via the From Motor Catalogue button, the motor catalogue can be opened to select another
motor.

Selecting a motor from the motor catalogue in the »Engineer« ( 139)
• Via the From drive... button, the motor data set in the controller can be copied to the »Engineer«
when an online connection has been established.
• When an online connection has been established to the controller, the Identification in
progress... button serves to automatically identify different motor data.  Automatic motor
data identification ( 141)
• The Encoder/feedback system... button serves to get to the settings for the encoder/feedback
system, if available.  Encoder/feedback system ( 314)