Lenze 8400 TopLine - Manual (Page 997)

Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
997
17 Parameter reference
17.2 Parameter list | C00490
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00490
C00491
C00492
Parameter | Name:
C00490 | Position encoder selection
Data type: UNSIGNED_8
Index: 24085
d
= 5E15
h
Selection of the feedback system for the generation of the actual position on the load
 Encoder/feedback system
Selection list (Lenze setting printed in bold) Info
0 No sensor: nSpeedSetValue_a No encoder available on the load.
The position signal dnMotorPosAct_p is derived from the
speed setpoint nSpeedSetValue_a.
1 Sensor signal FreqIn12 Position encoder signal is fed via digital inputs DI1 and
DI2
2 Encoder signal FreqIn67 Position encoder signal is fed via digital inputs DI6 and
DI7
3 Multi encoder Position encoder signal is supplied via multi-encoder
interface
4 Resolver Position encoder signal is supplied via resolver interface
5 Encoder signal FreqIn1267 From version 15.00.00
Position encoder signal is fed via digital inputs DI1/DI2
and DI6/DI7 (connection of 4-track HTL encoders)
10 Encoder selection C495 or
nVoltageAngleAct_a
From version 12.00.00
The position signal dnMotorPosAct_p is either calculated
from the set speed feedback (for C00495 > 0) or from the
speed signal nMotorSpeedAct_v (for C00495 = 0).
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00491 | Hiperface messages
Data type: UNSIGNED_8
Index: 24084
d
= 5E14
h
From version 14.00.00
Display range (min. value | unit | max. value)
0 255
Subcodes Info
C00491/1 Hiperface: Status 1
C00491/2 Hiperface: Status 2
C00491/3 Hiperface: Status 3
C00491/4 Hiperface: Status 4
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00492 | Hiperface: Detected TypCode
Data type: UNSIGNED_8
Index: 24083
d
= 5E13
h
From version 02.00.00
 Encoder/feedback system: sin/cos absolute value encoder with HIPERFACE® protocol
Display range
(min. value | unit | max. value)
0 255
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1