Lenze 8400 TopLine - Manual (Page 882)

17 Parameter reference
17.2 Parameter list | C00003
882
Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00003
Parameter | Name:
C00003 | Status of last device command
Data type: UNSIGNED_8
Index: 24572
d
= 5FFC
h
Status of the device command executed last ( C00002 ).
Note:
Before switching off the supply voltage after carrying out a device command, check whether the device command
has been carried out successfully via the status display!
 Drive control (DCTRL) : Device commands
Selection list (read only) Info
0 Successful Device command has been executed successfully.
1 Command unknown Device command implausible or unknown to the system.
2 Password protection Unauthorised access for requested device command.

Password protection
3 Time-out Device command could not be processed in the defined
time (timeout).
4 System fault
5 Command server assigned
6 Controller inhibit required
10 Memory module binding error  Device personalisation
11 Password too short  Password protection
12 Wrong password
13 Password already set
14 Password not assigned
20 Setting the hiperface position failed
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1