Lenze 8400 TopLine - Manual (Page 883)

Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
883
17 Parameter reference
17.2 Parameter list | C00005
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00005
C00006
Parameter | Name:
C00005 | Application
Data type: UNSIGNED_16
Index: 24570
d
= 5FFA
h
Selection of the technology application
Selection list
(Lenze setting printed in bold) Info
0 Wiring has changed This display appears if the FB interconnection has been
changed in the application level using the FB Editor.
1000 Actuating drive speed This technology application is used to solve speed-
controlled drive tasks, e.g. conveying belts.

TA "Actuating drive speed"
1100 Actuating drive speed (AC Drive
Profile)
From version 13.00.00
This technology application is used to solve speed-
controlled drive tasks, e.g. conveying belts.
The process data word received by the master control is
interpreted as "AC Drive Profile" control word.

TA "Actuating drive speed (AC Drive Profile)"
2000 Table positioning This technology application is used to solve position-
controlled drive tasks which are usually controlled by a
higher-level control system using a fieldbus.

TA "Table positioning"
3000 Switch-off positioning This technology application is used to solve speed-
controlled drive tasks which require a pre-switch off or
stopping at certain positions, e.g. roller conveyors and
conveying belts. This is implemented by connecting
switch-off sensors.

TA "Switch-off positioning"
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00006 | Motor control
Data type: UNSIGNED_8
Index: 24569
d
= 5FF9
h
Selection of the motor control mode
 Motor control (MCTRL) : Select control mode
Selection list (Lenze setting printed in bold) Info
1 SC: Servo control PSM This control type is used for the servo control of a
synchronous motor.
• The control type requires a speed feedback via an
encoder mounted to the motor!
 Servo control
2 SC: Servo control ASM This control type is used for the servo control of an
asynchronous motor.
• The control type requires a speed feedback via an
encoder mounted to the motor!
 Servo control
3 SLPSM: Sensorless PSM This control type is used for the sensorless control of a
synchronous motor.

Sensorless control for synchronous motors
4 SLVC: Vector control This control type is used for sensorless vector control of
an asynchronous motor.
• The control type requires motor parameters to be set
as exactly as possible!
 Sensorless vector control