Lenze 8400 TopLine - Manual (Page 832)

13 Fieldbus interface (MCI)
13.2 Control mode "MCI"
832
Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
13.2 Control mode "MCI"
"40: MCI" can be selected as a control mode in C00007 in order to quickly and easily set-up drive
controller control by means of MCI-PDOs via the fieldbus interface.
Given that the technology applications are fundamentally different and have different
requirements regarding the signals sent to them, predefined assignment of the MCI-PDOs depends
on the technology application selected in C00005 :
• TA "Actuating drive speed":
Process data assignment for fieldbus communication ( 450)
• TA "Table positioning":
Process data assignment for fieldbus communication ( 513)
• TA "Abschaltpositionierung":
Process data assignment for fieldbus communication ( 539)

Tip!
The predefined assignment of the MCI-PDOs can be parameterised by means of PDO
mapping and can be freely configured on the I/O level in the function block editor (FB
editor).