Lenze 8400 TopLine - Manual (Page 662)

9 Basic drive functions (MCK)
9.12 Holding brake control
662
Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Related topics:
 Behaviour in case of pulse inhibit ( 670)
 Feedforward control of the motor before release ( 671)
9.12.2.3 Switching thresholds
Upper speed threshold for brake release:
Switching threshold (
C02581/1 ) + hysteresis for release ( C02581/2 )
Lower speed threshold for brake application:
Switching threshold (
C02581/1 ) - hysteresis for application ( C02581/3 )

Tip!
The lower speed threshold for brake application should be set to approximately 5 ... 20 % of
the maximum speed to minimise the wear of the brake and provide for an optimum brake
reaction by a low grinding of the brake.
Related topics:
 Process when brake is released ( 667)
 Process when brake is closed ( 668)

Stop!
Do not set the lower speed threshold for closing the brake too high to prevent excessive
wear of the brake!

Note!
When comparing speeds, only the absolute value of the motor speed and not the
direction of rotation is considered.