ADTRAN 1000R Series - Manual (Page 1001)

Command Reference Guide Loopback Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1001
ip ospf
Use the ip ospf command to customize OSPF settings (if needed).
Syntax Description
authentication-key Specifies a simple-text authentication password to be used
by other routers using <password> the OSPF simple
password authentication.
cost <value> Specifies the OSPF cost of sending a packet on the interface.
This value overrides any computed cost value.
Range: 1 to 65,535.
dead-interval <seconds> Sets the maximum interval allowed between hello packets. If
the maximum is exceeded, neighboring devices will
determine that the device is down. Range: 0 to 32,767.
hello-interval <seconds> Specifies the interval between hello packets sent on the
interface. Range: 0 to 32767.
message-digest-key <keyid> md5 <key> Configures OSPF Message Digest 5 (MD5) authentication
(16-byte max) keys.
priority <value> Set the OSPF priority. The value set in this field helps
determine the designated router for this network.
Range: 0 to 255.
retransmit-interval <seconds> Specifies the time between link-state advertisements (LSAs).
Range: 0 to 32,767.
transmit-delay <seconds> Sets the estimated time required to send an LSA on the
interface. Range: 0 to 32,767.
Default Values
retransmit-interval <seconds> 5 seconds
transmit-delay <seconds> 1 second
hello-interval <seconds> 10 seconds: Ethernet, point-to-point, Frame Relay, and PPP
dead-interval <seconds> 40 seconds
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 3.1 Command was introduced.