ADTRAN 1000R Series - Manual (Page 203)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 203
show interfaces switchport [vlans]
The show interfaces switchport command displays the operational and configured state of switch-specific
parameters on all ports.
Syntax Description
vlans Shows VLAN membership information for a specific switchport or series of
switchports.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, and 2000 Series units.
Command History
Release 6.1 Command was introduced.
Release 10.1 VLANS option was introduced.
Functional Notes
The output of this command is restricted to switch-only information.
Usage Examples
The following is sample output from the show interfaces switchport command:
>enable
#show interfaces switchport
Name: eth 0/1
Switchport: enabled
Administrative mode: access
Negotiation of Trunking: access
Access mode VLAN: 1
Trunking Native mode VLAN: 1
Trunking VLAN Enabled: 1-4094
Name: eth 0/2
Switchport: enabled
Administrative mode: access
Negotiation of Trunking: access
Access mode VLAN: 12.....