ADTRAN 1000R Series - Manual (Page 1308)

Command Reference Guide Router (OSPF) Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1308
maximum paths <number>
Use the maximum paths command to set the maximum number of multipath routes to advertise to the
route table via OSPF.
Syntax Description
<number> Specifies the number of routes OSPF can insert into the route table.
Valid range: 1 to 6.
Default Values
By default, maximum paths is set to 4.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 11.1 Command was introduced.
Usage Examples
The following example sets the maximum number of multipath routes OSPF can insert in the route table to
5.
(config)#router ospf
(config-ospf)#maximum paths 5