ADTRAN 1000R Series - Manual (Page 739)

Command Reference Guide ATM Sub-Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 739
dial-backup restore-delay <seconds>
Use the dial-backup restore-delay command to configure the amount of time the router will wait after the
network is restored before disconnecting the backup link and reverting to the primary. This setting is used
to prevent disconnecting the backup link if the primary link is “bouncing” in and out of alarm.
Syntax Description
<seconds> Specifies the number of seconds the AOS will wait (after a primary link is restored)
before disconnecting dial-backup operation (valid range: 10 to 86,400).
Default Values
By default, the dial-backup restore-delay period is set to 10 seconds.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 1.1 Command was introduced.
Release 8.1 ATM sub-interface was added.
Usage Examples
The following example configures the AOS to wait 30 seconds before disconnecting dial-backup operation
and restoring the primary connection for this endpoint:
(config)#interface atm 1.1
(config-atm 1.1)#dial-backup restore-delay 30