ADTRAN 1000R Series - Manual (Page 1279)

Command Reference Guide BGP Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1279
bgp router-id <ip address>
Use the bgp router-id command to specify the IP address that the router should use as its BGP router ID.
Use the no form of this command to return to the default setting.
Syntax Description
<ip address> Designates the IP address this router should use as its BGP router ID.
Default Values
By default, no router ID is configured. The default action is detailed in Functional Notes, below.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 8.1 Command was introduced.
Functional Notes
This command allows an IP address to be specified for use as the BGP router ID. If no IP address is
configured at BGP startup, it uses the highest IP address configured on a loopback interface. If no
loopback interfaces are configured, it uses the highest IP address configured on any interface that is
active. If the specified router ID is changed, existing sessions with BGP neighbors are reset.
Usage Examples
The following example configures IP address 10.0.0.1 as the BGP router ID:
(config)#router bgp 1
(config-bgp)#bgp router-id 10.0.0.1