ADTRAN 1000R Series - Manual (Page 1006)

Command Reference Guide Loopback Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1006
ip rip receive version [1 | 2]
Use the ip rip receive version command to configure the RIP version the unit accepts in all RIP packets
received on the interface.
Syntax Description
1 Accepts only received RIP version 1 packets on the interface.
2 Accepts only received RIP version 2 packets on the interface.
Default Values
By default, all interfaces implement RIP version 1 (the default value for the version command).
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 1.1 Command was introduced.
Functional Notes
Use the ip rip receive version to specify a RIP version that overrides the version (in the Router RIP)
configuration.
The AOS only accepts one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures the loopback interface to accept only RIP version 2 packets:
(config)#interface loopback 1
(config-loop 1)#ip rip receive version 2