ADTRAN 1000R Series - Manual (Page 790)

Command Reference Guide Demand Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 790
connect-mode [answer | originate | either]
Use the connect-mode command to configure the interface to only answer calls, only originate calls, or to
both answer and originate calls. Use the no form of this command to restore the default values.
Syntax Description
answer Specifies the interface may be used to answer calls but not originate calls.
originate Specifies the interface may be used to originate calls but not answer calls.
either Specifies the interface may be used to answer and originate calls.
Default Values
By default the connect mode is set to both answer and originate calls.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 11.1 Command was introduced.
Usage Examples
The following example configures demand interface 1 to only answer calls:
(config)#interface demand 1
(config-demand 1)#connect-mode answer