Match metric <value – ADTRAN 1000R Series User Manual
Page 1358
Command Reference Guide
Route Map Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
1358
match metric <value>
Use the match metric command to configure the route map to route traffic based on a specified metric
value. Use the no form of this command to discontinue matching.
Syntax Description
<value>
Specifies the metric value you want to match. (Valid range: 1 to
4,294,967,295.)
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 Series and
Total Access 900 Series units.
Command History
Release 10.1
Command was introduced.
Usage Examples
The following example instructs the route map named MyMap to match the metric value 100:
(config)#route-map MyMap permit 100
(config-route-map)#match metric 100