ADTRAN 1000R Series - Manual (Page 215)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 215
show ip bgp <network ip> [</length> | <network-mask>]
Use the show ip bgp <network ip> command to display details about the specified route, including the
advertising router IP address, router ID, and the list of neighbors to which this route is being advertised.
Syntax Description
<network ip> Shows only routes for the specified network.
</length> Optional. Shows only routes for the specified network matching the prefix length
(e.g., /24).
<network-mask> Optional. Shows only routes for the specified network matching the network mask
(e.g., 255.255.255.0).
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 8.1 Command was introduced.
Usage Examples
The following example shows detailed output of this command:
>enable
#show ip bgp 10.15.240.0/28
BGP routing table entry for 10.15.240.0/28
Paths: (1 available, best #1)
Advertised to peers:
1.1.5.10
100 1
10.15.43.17 from 10.15.43.17 (8.1.1.1)
Origin IGP, metric 2, valid, external, best