Show users [realtime – ADTRAN 1000R Series User Manual
Page 311
Command Reference Guide
Enable Mode Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
311
show users [realtime]
Use the show users command to display the name (if any) and state of users authenticated by the system.
Displayed information includes:
•
Connection location (for remote connections this includes Transmission Control Protocol (TCP)
information)
•
Username of authenticated user
•
Current state of the login (in process or logged in)
•
Current enabled state
•
Time the user has been idle on the connection
Syntax Description
realtime
Displays full-screen output in real time. See the Functional Notes below for more
information.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 5.1
Command was introduced.
Release 10.1
The real time display option was introduced.
Functional Notes
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to