ADTRAN 1000R Series - Manual (Page 324)

Command Reference Guide Global Configuration Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 324
G LOBAL C ONFIGURATION M ODE C OMMAND S ET
To activate the Global Configuration mode, enter the configuration command at the Enable Security
mode prompt. For example:
>enable
#configure terminal
(config)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
aaa accounting commands begin on page 327
aaa authentication commands begin on page 330
aaa authorization commands begin on page 336
aaa group server [radius | tacacs+] <listname> on page 338
aaa on on page 340
aaa processes <threads> on page 342
arp <ip address> <mac address> arpa on page 343
auto-config [filename <name> | restart | retry-count <number>| server <name or address>] on
page 344
banner [exec | login | motd] <character> <message> <character> on page 346
boot config [cflash | flash] <filename> [cflash | flash] <backup filename> on page 347
boot system flash <filename> [no-backup | <backup filename>] on page 348
bridge <group#> protocol ieee on page 349
clock [auto-correct-dst | no-auto-correct-dst] on page 350
clock set <time> <day> <month> <year> on page 351
clock timezone <text> on page 352
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on
page 355