ADTRAN 1000R Series - Manual (Page 244)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 244
show lldp interface <interface>
Use the show lldp interface command to display local loop demarkation point (LLDP) configuration and
statistics for interfaces on this device.
Syntax Description
<interface> Displays the information for the specified interface. Type show lldp interface ?
for a complete list of applicable interfaces.
Default Values
No default values are necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 8.1 Command was introduced.
Usage Examples
The following example shows LLDP configuration and statistics for the Ethernet 0/1 interface:
>enable
#show lldp interface ethernet 0/1
eth 0/1 (TX/RX)
0 packets input
0 input errors
0 TLV errors, 0 TLVs Discarded
0 packets discarded
8799 packets output
0 neighbor ageouts
#