ADTRAN 1000R Series - Manual (Page 630)

Command Reference Guide Ethernet Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 630
port-auth auth-mode [mac-based | port-based]
Use the port-auth auth-mode command to configure the authentication mode. Use the no form of this
command to return to the default settings.
Syntax Description
mac-based Specifies a MAC-based authentication mode. Each host must authenticate
separately.
port-based Specifies a port-based authentication mode. Only a single host can participate in
the authentication process.
Default Values
By default, th e authentication mode is port-based.
Applicable Platforms
This command applies to the NetVanta 1000 and 1000R Series units.
Command History
Release 10.1 Command was introduced.
Usage Examples
The following example configures the unit for MAC-based authentication mode:
(config)#interface ethernet 0/1
(config-eth 0/1)#port-auth auth-mode mac-based