ADTRAN 1000R Series - Manual (Page 1037)

Command Reference Guide PPP Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1037
PPP I NTERFACE C ONFIGURATION C OMMAND S ET
To activate the PPP Interface Configuration mode, enter the interface ppp command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface ppp 1
(config-ppp 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname> on page 1039
alias link<“text”> on page 1042
bandwidth <value> on page 1043
bridge-group commands begin on page 1044
crypto map <mapname> on page 1045
dial-backup commands begin on page 1047
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username>
<password> on page 1064
fair-queue <threshold> on page 1066
hold-queue <queue size> out on page 1067
ip commands begin on page 1068
keepalive <seconds> on page 1087
lldp receive on page 1088
lldp send [management-address l port-description l system-capabilities l system-description l
system-name l and-receive] on page 1089