ADTRAN 1000R Series - Manual (Page 687)

Command Reference Guide SHDSL Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 687
boot alternate-image
Use the boot alternate-image command to execute new code after a firmware upgrade.
Syntax Description
No subcommands.
Default Values
No defaults necessary for this command.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 3.1 Command was introduced.
Functional Notes
The current SHDSL NIM card (1200867L1) supports two code images commonly referred to as the “active”
image and the “inactive” image. When a firmware upgrade is performed on the card (through the copy
<filename> interface shdsl x/y Enable mode command), the new firmware is placed in the “inactive”
image space. This new code will not be executed until the boot alternate-image command is issued.
When the user does this, the NIM will reboot (taking the current line down) with the new code. At this point,
the old code becomes the “inactive” image and the new recently updated code becomes the “active”
image.
Usage Examples
The following example causes the firmware upgrade to take effect:
(config)#interface shdsl 1/1
(config-shdsl 1/1)#boot alternate-image