Port channel interface config command set, Port channel interface config command set 3 – ADTRAN 1000R Series User Manual
Page 1013
Command Reference Guide
Port Channel Interface Config Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
1013
P
ORT
C
HANNEL
I
NTERFACE
C
ONFIG
C
OMMAND
S
ET
To activate the Port Channel Interface Configuration mode, enter the interface port-channel command at
the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface port-channel 1
(config-p-chan 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
All other commands for this command set are described in this section in alphabetical order.
qos [trust cos | default-cos <cos value>]
spanning tree commands
begin on page 1021
storm-control [broadcast level | multicast level | unicast level] <rising level> <falling level>
storm-control action [shutdown]
switchport commands
begin on page 1030