ADTRAN 1000R Series - Manual (Page 614)

Command Reference Guide Ethernet Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 614
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
arp arpa on page 616
bridge-group <group#> on page 617
channel-group <group#> mode on on page 618
crypto map <mapname> on page 619
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username> <password> on
page 621
full-duplex on page 623
half-duplex on page 625
lldp receive on page 626
lldp send [management-address l port-description l system-capabilities l system-description l
system-name l and-receive] on page 627
Not all Ethernet commands apply to all Ethernet types. Use the ? command to display a list
of valid commands. For example:
>enable
Password:xxxxx
#config term
(config)#int eth 0/1
(config-eth 0/1)#?
access-policy - Assign access control policy for this interface
alias - A text name assigned by an SNMP NMS
arp - Set ARP commands
bandwidth - Set bandwidth informational parameter
bridge-group - Assign the current interface to a bridge group
etc....