Ip ospf network [broadcast | point-to-point – ADTRAN 1000R Series User Manual
Page 1204
Command Reference Guide
VLAN Interface Config Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
1204
ip ospf network [broadcast | point-to-point]
Use the ip ospf network command to specify the type of network on this interface.
Syntax Description
broadcast
Sets the network type for broadcast.
point-to-point
Sets the network type for point-to-point.
Default Values
By default, Ethernet defaults to broadcast. PPP and Frame Relay default to point-to-point.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, and 2000 Series units.
Command History
Release 3.1
Command was introduced.
Functional Notes
A point-to-point network will not elect designated routers.
Usage Examples
The following example designates a broadcast network type:
(config)#interface vlan 1
(config-interface-vlan 1)#ip ospf network broadcast