ADTRAN 1000R Series - Manual (Page 983)

Command Reference Guide Loopback Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 983
L OOPBACK I NTERFACE C ONFIGURATION C OMMAND S ET
To activate the Loopback Interface Configuration mode, enter the interface loopback command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface loopback 1
(config-loop 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname> on page 984
bandwidth <value> on page 987
crypto map <mapname> on page 988
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username> <password> on
page 990
ip commands begin on page 992
ip commands begin on page 993
mtu <size> on page 1010
snmp trap on page 1011
snmp trap link-status on page 1012