ADTRAN 1000R Series - Manual (Page 254)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 254
show mac address-table dynamic
Use the show mac address-table dynamic command to display all dynamic medium access control
(MAC) addresses learned by the AOS.
Variations of this command include the following:
show mac address-table dynamic
show mac address-table dynamic address <mac address>
show mac address-table dynamic address <mac address> interface <interface type> <interface id>
show mac address-table dynamic address <mac address> interface <interface type> <interface id>
vlan <vlan id>
show mac address-table dynamic address <mac address> vlan <vlan id>
show mac address-table dynamic interface <interface type> <interface id>
show mac address-table dynamic interface <interface type> <interface id> vlan <vlan id>
show mac address-table dynamic vlan <vlan id>
Syntax Description
address <mac address> Specifies a valid 48-bit MAC address.
interface <interface type> Shows information for a specific interface. Type show mac address-table
dynamic interface ? for a list of valid interfaces.
<interface id> Specifies a valid slot/port interface ID (e.g., 0/1).
vlan <vlan id> Specifies a valid VLAN interface ID (1 to 4094).
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, and 2000 Series units.
Command History
Release 5.1 Command was introduced.