ADTRAN 1000R Series - Manual (Page 1254)

Command Reference Guide IKE Policy Attributes Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1254
IKE P OLICY A TTRIBUTES C OMMAND S ET
To activate the IKE Policy Attributes mode, enter the attribute command at the IKE Policy prompt. For
example:
>enable
#configure terminal
(config)#crypto ike policy 1
(config-ike)#attribute 10
(config-ike-attribute)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
authentication [dss-sig | pre-share | rsa-sig] on page 1255
encryption [aes-xxx-cbc | des | 3des] on page 1256
group [1 | 2] on page 1257
hash [md5| sha] on page 1258
lifetime <seconds> on page 1259
For VPN configuration example scripts, refer to the technical support note
Configuring VPN located on the ADTRAN OS Documentation CD provided with your
unit.