ADTRAN 1000R Series - Manual (Page 1321)

Command Reference Guide Router (RIP) Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1321
redistribute connected [metric <value>]
Use the redistribute connected command to pass routes from one network to another, regardless of the
routing protocol implemented on the routing domain. Using the connected keyword allows the
propagation of routes connected to other interfaces using the RIP routing protocol. Use the no form of this
command to disable the propagation of the specified route type.
Syntax Description
metric <value> Optional. Specifies the hop count to use for advertising redistributed OSPF routes
in RIP.
Default Values
By default, RIP is not enabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 3.1 Command was introduced.
Functional Notes
Redistributing connected routes imports those routes into RIP without the interfaces in question actually
participating in RIP. The connected routes imported this way are not covered by a network command and
therefore do not send/receive RIP traffic.
Usage Examples
The following example passes the connected routes found in the route table to other networks running the
RIP routing protocol:
(config)#router rip
(config-rip)#redistribute connected