ADTRAN 1000R Series - Manual (Page 464)

Command Reference Guide Global Configuration Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 464
logging email priority-level [error | fatal | info | notice | warning]
Use the logging email priority-level command to set the threshold for events sent to the addresses
specified using the logging email address-list command. All events with the specified priority or higher
will be sent to all addresses in the list. The logging email on command must be enabled. Refer to logging
email address-list <email address> ; <email address>
on page 461 and logging email on on page 463 for
related information. Use the no form of this command to return to the default priority.
Syntax Description
Sets the minimum priority threshold for sending messages to email addresses specified using the logging
email address-list command.
The following priorities are available (ranking from lowest to highest):
error Logs events with error and fatal priorities.
fatal Logs only events with a fatal priority.
info Logs all events.
notice Logs events with notice, warning, error, and fatal priorities.
warning Logs events with warning, error, and fatal priorities.
Default Values
By default, the logging email priority-level is set to warning.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1 Command was introduced.
Usage Examples
The following example sends all messages with warning level or greater to the email addresses listed
using the logging email address-list command:
(config)#logging email priority-level warning