ADTRAN 1000R Series - Manual (Page 1167)

Command Reference Guide VLAN Database Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1167
VLAN D ATABASE C ONFIGURATION C OMMAND S ET
To activate the Config VLAN Database mode, enter the vlan database command at the Enable security
mode prompt. For example:
>enable
#vlan database
(vlan)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
do on page 32
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
abort on page 1168
apply on page 1169
reset on page 1170
show [changes <vlan id> | current | proposed] on page 1171
vlan <vlan id> on page 1172
vlan <vlan id> media [ethernet] on page 1173
vlan <vlan id> name <vlan name> on page 1174
vlan <vlan id> state [active | suspend] on page 1175