ADTRAN 1000R Series - Manual (Page 250)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 250
show mac address-table address
Use the show mac address-table address command to display all medium access control (MAC)
addresses known by the AOS.
Variations of this command include the following:
show mac address-table address <mac address>
show mac address-table address <mac address> interface <interface type> <interface id>
show mac address-table address <mac address> interface <interface type> <interface id>
vlan <vlan id>
show mac address-table address <mac address> vlan <vlan id>
Syntax Description
<mac address> Specifies a valid 48-bit MAC address.
interface <interface type> Shows information for a specific interface. Type show mac address-table
address interface ? for a list of valid interfaces.
<interface id> Specifies a valid slot/port interface ID (e.g., 0/1).
vlan <vlan id> Specifies a valid VLAN interface ID (1 to 4094).
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, and 2000 Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following sample from the show mac address-table address command displays information regarding a
specific MAC address from the MAC address table:
>enable
#show mac address-table address 00:a0:c8:7d:30:00
Mac Address Table
------------------------------------------
Vlan Mac Address Type Ports
-------- -------------------- --------- -----------
2 00:a0:c8:7d:30:00 DYNAMIC eth 0/1