ADTRAN 1000R Series - Manual (Page 723)

Command Reference Guide ATM Sub-Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 723
bridge-group <group#>
Use the bridge-group command to assign an interface to the specified bridge group. Use the no form of
this command to remove the interface from the bridge group.
Syntax Description
<group#> Assigns a bridge group number to the interface (range is 1 to 255).
Default Values
By default, there are no configured bridge groups.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, and 4000 Series units.
Command History
Release 1.1 Command was introduced.
Release 8.1 ATM sub-interface was added.
Functional Notes
A bridged network can provide excellent traffic management to reduce collisions and limit the amount of
bandwidth wasted with unnecessary transmissions when routing is not necessary. Any two interfaces can
be bridged (Ethernet to T1 bridge, Ethernet to Frame Relay sub-interface).
Usage Examples
The following example assigns the ATM sub-interface labeled 1.1 to bridge group 1:
(config)#interface atm 1.1
(config-atm 1.1)#bridge-group 1